Hi, My Rainbow E series power nozzle keeps shutting off unless I vacuum at level 3. I can only vacuum for a little while before it starts to whine a bit, then trips the overload. How can I tell if it’s the motor or the overload switch? Thanks.
|
||||||
Miele vacuum S4212 Polaris with SBD 450 - 3 Combination Carpet/Smooth floor tool
(Recommended for: short-pile carpeting, area rugs and smooth flooring)
Learn More
S4212 Neptune with STB 205-3 Turbo Comfort Brush(Recommended for: low to medium-pile carpeting, area rugs and smooth flooring)
Learn More
S5281 Callisto with SEB217-3 Powerbrush
(Recommended for: medium-to high pile carpeting, area rugs and smooth flooring)
Learn More |
Rainbow E Series Power nozzle problem3 comments to Rainbow E Series Power nozzle problem |
|||||
|
Copyright © 2010 Vacuum Cleaner Repair and Installation Tips – Free! - All Rights Reserved |
||||||
Mae,
The fact that you said you can hear your motor whining and that it will run for a while except under some stress sounds like a bad motor. But here’s a couple things to try first; make sure that your belt is not too tight. A genuine Rainbow belt is best, but a generic belt is OK too as long as it was designed for a Rainbow and is not too short. Next, remove the brush roll. Hold the end caps and spin the brush roll. If it does not spin freely then check for debris or hair and remove. Also check the bushings/bearings. If they are bad then you should replace them or the entire brush roll.
Unfortunately, the only way to determine if the circuit breaker(overload) or motor is bad is to replace one or the other. We personally think that your motor is the most likely problem since you said it whines and then stops under a load.
I hope this helps.
I need picture for motor fan e-2 series and prise. T.U.
electric cord on power nozzle not making connection series SE PN2