Here’s how to determine which style HEPA filter your Rainbow E Series vacuum will use.
Rainbow HEPA Filter R7292
Rainbow HEPA Filter R10520
Rainbow HEPA Filter R12179
|
||||||
|
|
rainbow d4c-se How do I change the motor filter on a Rainbow E Series vacuum cleaner? My brush in my power nozzle is slow and jerky, and of course will not pick anything up. It is the older e series. I have to replace the on/off switch, the new switch has 4 wires, the old wires have 2 from the motor 2 from the power cord and 2 from the plug. what wires can be connected? Reprinted from previous comments: “When I sweep, the Rainbow smells really bad like something is burning inside of it but I don’t know how to dismantle it to see what is going on. Any help would be appreciated. Thank you. Vacuum smells like something is burning, smells like burnt rubber” This is best answered with this related Continue reading: This is a complete, step-by-step procedure that will show how to disassemble a Rainbow D4, D4C or D4C SE vacuum Cleaner. With each step we’ll show you how to clean, service or replace every part. The interior of the Rainbow D4C collects a lot of dirt over the years; all plastic and metal Continue reading: No power to motor on Rainbow D4. Tracing the line we found a small silver fitting that looks like a diode. No power after (motor side ) of the thing. Local Radio Shack can’t identify the small part, think it is a diode, but is it a fuse? What is it and where can we Continue reading: What is the seal located under the motor just inside of the water bowl gasket and is it easy to remove and replace? we have a rainbow ‘E’ series vacuum and can not remove the acorn nut. we tried spraying wd-40 to loosen it , but no luck. ANY SUGGESTIONS! The motor will not turn on. But the nozzle motor will run, but not pick up. Purchase a new separator with brass nut [wp_cart:E Series separator and nut:price:22.59:end] Continue reading: Question: i have a rainbow se and the powerhead will not work. the power indicator light comes on but the brush won’t spin. now when i took it apart and put it back together it ran for a minute then stopped. i opened it again and redid one wire connection because it seemed loose. again Continue reading: Question:my daughter’s rainbow E2 quit, trying to fix it, I push the interlock switch and it runs? is there something that holds that switch in? could it be the interlock plunger? did it fall out? HELP! Answer: Refer to the drawing below. # 12 is the safety switch interlock post. Your Rainbow E2 will not run if Continue reading: Question: My Rainbow E series vacuum smells like rubber burning when I use the carpet nozzle – what’s the problem. Answer: There is a problem with the belt; it’s either stretched enough so that the motor shaft is spinning while the belt stays still or your brush roll is clogged with debris(or the brush roll bearings Continue reading: How do you get a hold of some new carbon brushes for my E Series Vacuum cleaner? we have a rainbow ‘E’ series vacuum and can not remove the acorn nut. we tried spraying wd-40 to loosen it , but no luck. ANY SUGGESTIONS! The motor will not turn on. But the nozzle motor will run, but not pick up. |
 |
||||
|
Copyright © 2010 Vacuum Cleaner Repair and Installation Tips – Free! - All Rights Reserved |
||||||
